- 17_final_exterior.JPG
The finished box. - 18_final_interior.JPG
- 18_final_computer.JPG
Interior of the finished box. - 01_cam_model.JPG
The CAM software at the Sawdust Shop showing the control board layout to be CNC'd. - 19_final_ext_rear.JPG
Rear view of the finished box. - 13_ultimarc_mount.JPG
Bryan drills holes to mount the Ultimarc keyboard encoder. - 08_drill_for_MB_mount.JPG
We drill holes for the machine bolts that will hold the motherboard in place. - 12_button_install.JPG
Back at home, we start to assemble the top panel. We use two buttons to align the poster, then trim it around the edges. - 14_doug_solders_buttons.JPG
Doug solders the ground loop with the help of Negra Modelo. - 16_wire_closeup.JPG
- 06_laser_template.JPG
On a second trip to the Sawdust Shop, we use the laser cutter to make a template for routing out some MDF at the joystick mounts. - 05_cnc_drills.JPG
CNC machine begins drilling holes. - 10_glue_prepare.JPG
The lower box pieces aligned for gluing. - 11_glue_clamped.JPG
The box, glued and clamped. - 07_bryan_routes_joysticks.JPG
Bryan uses the template to route out an extra 3/8" of material so the joysticks will extend higher from the top of the panel. - 09_mb_mount_test.JPG
Hey look, we drilled the holes in the right place! - 04_george_cnc.JPG
George approves. - 03_cnc_starts.JPG
The CNC machine prepares to cut out the control board and box pieces. - 02_cam_model.JPG
- 15_finished_soldering.JPG
The finished wiring job. Doug does gorgeous work.