cthulhu_close.jpg
cthulhu_context.jpg
19_final_ext_rear.JPG
Rear view of the finished box.
18_final_computer.JPG
Interior of the finished box.
18_final_interior.JPG
17_final_exterior.JPG
The finished box.
16_wire_closeup.JPG
15_finished_soldering.JPG
The finished wiring job. Doug does gorgeous work.
14_doug_solders_buttons.JPG
Doug solders the ground loop with the help of Negra Modelo.
13_ultimarc_mount.JPG
Bryan drills holes to mount the Ultimarc keyboard encoder.
12_button_install.JPG
Back at home, we start to assemble the top panel. We use two buttons to align the poster, then trim it around the edges.
11_glue_clamped.JPG
The box, glued and clamped.
10_glue_prepare.JPG
The lower box pieces aligned for gluing.
09_mb_mount_test.JPG
Hey look, we drilled the holes in the right place!
08_drill_for_MB_mount.JPG
We drill holes for the machine bolts that will hold the motherboard in place.![07_bryan_routes_joysticks.JPG](users/overt/_data/i/users/overt/menalto_albums/life/20090216/07_bryan_routes_joysticks-la.JPG "07_bryan_routes_joysticks.JPG (1715 visits) Bryan uses the template to route out an extra 3/8" of material so the joysticks will extend hig...")
07_bryan_routes_joysticks.JPG
Bryan uses the template to route out an extra 3/8" of material so the joysticks will extend higher from the top of the panel.
06_laser_template.JPG
On a second trip to the Sawdust Shop, we use the laser cutter to make a template for routing out some MDF at the joystick mounts.
05_cnc_drills.JPG
CNC machine begins drilling holes.
04_george_cnc.JPG
George approves.
03_cnc_starts.JPG
The CNC machine prepares to cut out the control board and box pieces.
02_cam_model.JPG
01_cam_model.JPG
The CAM software at the Sawdust Shop showing the control board layout to be CNC'd.